FAQ's

  • Are there any specific cleaning requirements for the simulators?

    Cleaning Instructions for Inovus Simulators

    1. General Guidance

    • Always disconnect the simulator from power (if applicable) before cleaning.
    • Do not submerge any part of the simulator in water.
    • Avoid excessive moisture around electronic components, cameras, or light sources.

    2. Routine Cleaning (After Each Use)

    1. Remove instruments and accessories from the simulator.
    2. Using a soft cloth or disposable wipe, clean all surfaces of the simulator.
    3. Prepare a mild cleaning solution using warm water and a small amount of liquid soap, or use an off-the-shelf disinfectant wipe.
    4. Wipe all external surfaces, including:
      • Top cover and outer housing
      • Ports and trocars
      • Internal workspace (silicone or plastic surfaces)
    5. For camera lenses, use a soft, non-abrasive cloth. Avoid harsh chemicals.

    3. Disinfection

    • After cleaning, use either:
      • A general household disinfectant wipe, or
      • A cloth lightly moistened with a dilute soap-and-water solution
    • Wipe all handled areas, including instrument grips and port surrounds.
    • Allow surfaces to air-dry fully before the next use.

    4. Important Warnings

    • Do not use bleach, acetone, solvents, or abrasive cleaners.
    • Do not spray liquids directly onto the simulator, apply to cloth first.
    • Do not attempt to sterilise parts using heat, autoclave, or chemical immersion.

    5. Frequency

    • After every session: Wipe down all surfaces as above.
    • Weekly (or more often in high-use environments): Perform a more thorough wipe-down of all internal and external surfaces.